Energizer PORTABLE GAS DETECTION INSTRUMENT Bedienungsanleitung PDF herunterladen (Seite 28)

IX. i-module replacement

1. Ensure you are in a non-hazardous (safe) area.

Switch off the unit

2. Remove any accessories, such as the flow adaptor, if fitted.

3. Remove the front cover grille by unscrewing the M3, 2 mm Allen screw

as shown the in the drawing, point 

4. Unscrew the side retaining M4, 3 mm Allen screws as shown in .

5. Remove the three sensor plate retaining screws as shown by point .

6. Ease the top away from the body, point .

7. Press down lightly on the rubber seal protecting the sensor housing

and slide forward, to clear the internal chassis from the sensor plate

aperture. With care, withdraw the whole instrument assembly.

Removing an installed i-module

1. Locate the i-module connection ribbon, squeeze the two retaining

lugs, on the module board, toward each other and pull out slightly,

this will release the ribbon.

2. Remove the retaining ring from the clips. Unclip the i-module from the

i-module replacement Tetra

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34 35 36

Keine Kommentare

Energizer PORTABLE GAS DETECTION INSTRUMENT Bedienungsanleitung Seite 28